Advice needed on delamination repair
One sidewall of the cabover of my Class-C had a lot of delamination. The previous owner had apparently replaced the Filon and luan in this area before, so I just took off the edge molding and pried of...
Forum Discussion
Thanks to everyone for your thoughts and ideas!
I like the idea of Lexan to use in lieu of luan, as suggested by FourthclassC, but a sheet big enough for the whole job would cost close to $200. However, an acrylic sheet of the required thickness is much cheaper. Anyone have any thoughts on using acrylic in lieu of luan as the layer between foam and filon?
I like the idea of Lexan to use in lieu of luan, as suggested by FourthclassC, but a sheet big enough for the whole job would cost close to $200. However, an acrylic sheet of the required thickness is much cheaper. Anyone have any thoughts on using acrylic in lieu of luan as the layer between foam and filon?
