Atwood Stove Increase in BTU's?
The typical Atwood stove has one 9600btu and two 6000 btu's in the back. Is there anyway to increase the heat output of the three? Even getting the other two up to the same 9600 would be a start. ...
Forum Discussion
Hi Westend,
I set it at 230 F. It drew 74 amps, until it reached that temperature then it started to cycle. I could not get a reading from the ammeter on the Magnum remote--so here is what happens in watts 760,120,450,760 (and repeat). I don't know why it cycles like that--and it happens fairly quickly.
It does appear to boil water at the 200 F setting.
Sorry for being tardy in replying.
I set it at 230 F. It drew 74 amps, until it reached that temperature then it started to cycle. I could not get a reading from the ammeter on the Magnum remote--so here is what happens in watts 760,120,450,760 (and repeat). I don't know why it cycles like that--and it happens fairly quickly.
It does appear to boil water at the 200 F setting.
Sorry for being tardy in replying.
westend wrote:
Pianotuna,
What is the 12V draw of that Nuwave plate at boiling temp? I know it's a 120V device, just curious if you've measured it or noticed on your monitor.
