Atwood water heater burnt 110v wire
Hello. looking for troubleshooting help on a Atwood GC6AA-9E water heater in a 2001 Prowler 275J. I usually only use the 110V to heat the water. When I turned on the unit and waited, but no hot water....
Forum Discussion
Most likely a bad or loose wire connection. Bad connection equals resistance. Resistance and current flow equals heat. Think of a light bulb. The filament (resistor) has current flowing thru it and it gets so hot it glows. At about 12 amps current it doesn’t take much resistance to create a lot of heat.
