Balanced Charging X's 4 6V Batteries
As I've recently started a campaign returning to basics on the care and feeding of my soon to be replaces X's 4 L16's - I have a follow up question. I've confirmed proper wiring to yield parallel/s...
Forum Discussion
Negative. Done correctly, I have less than .4 volt TOTAL DROP end to end at maximum load. The parallel bridge cables are done at one end the same end.
The batteries have "L" pad posts. I used a mill file to establish absolutely parallel full face conductivity. When mating surfaces are 100% contact, full load breakdown is minimal. I IR shoot the entire bank after 400+ amp recharging for >20 minutes.
The batteries have "L" pad posts. I used a mill file to establish absolutely parallel full face conductivity. When mating surfaces are 100% contact, full load breakdown is minimal. I IR shoot the entire bank after 400+ amp recharging for >20 minutes.
