Best Way??
I have 4-Canadian SC6P-220w Panels with the following spec's, Pmax=220W Voc =36.60V ISC =8.09A VMP =29.30V Imp =7.52A Voc-coef =0.1281V/C Noct =45.00C 15A fuse rating/series Per actual meas...
Forum Discussion
OK Guys,
Next step,
if I am forgetting or missing ANYTHING, feel free to advise me.
I have the 2-8ga parallel wires comning from the panels to the reefer vent and dropping straight down into the OEM electrical bay where the MS MPPT CC is going to be installed.
Do I need to do anything special to attach the panel wires to the charge controller? Can I attach the panel wires directly to the CC?
From the CC, I can then run the 2awg wires to the 4-GC batteries,
Do I need a fuse between the CC and batteries?
Tia,
Don
Next step,
if I am forgetting or missing ANYTHING, feel free to advise me.
I have the 2-8ga parallel wires comning from the panels to the reefer vent and dropping straight down into the OEM electrical bay where the MS MPPT CC is going to be installed.
Do I need to do anything special to attach the panel wires to the charge controller? Can I attach the panel wires directly to the CC?
From the CC, I can then run the 2awg wires to the 4-GC batteries,
Do I need a fuse between the CC and batteries?
Tia,
Don
