Copper sleeve?
If you have a 1/0 copper cable, then swaged a dead soft copper sleeve reducer over/onto to this 1/0 copper cable to fit a #2 awg sized cable fitting, would the resistance be higher or lower? Tia, ...
Forum Discussion
Smkettner,
This ia a SWAG on the length at this time, but from rough floor measurements, it appears to be right around 8-10' max (one way) from the battery to the MS MPPT 60a CC.
Once I get the bottom coroplast covering off, I will have a more accuate measurement, plus I also plan on updating the OEM 10ga wire run to the front 2 batteries which has a 20'+ (one way) from the 9260 converter, this explains why these 2 front tongue batteries were never fully charged, no matter how long I ran the gen set.
Tia,
Don
This ia a SWAG on the length at this time, but from rough floor measurements, it appears to be right around 8-10' max (one way) from the battery to the MS MPPT 60a CC.
Once I get the bottom coroplast covering off, I will have a more accuate measurement, plus I also plan on updating the OEM 10ga wire run to the front 2 batteries which has a 20'+ (one way) from the 9260 converter, this explains why these 2 front tongue batteries were never fully charged, no matter how long I ran the gen set.
Tia,
Don
smkettner wrote:
How long is the 1/0? I would try to just use #2 without worry.
