Dishwasher water pressure issue
Ever since we bought our RV (new), we have noticed that the Fisher-Paykel dishwasher often is unable to complete a wash cycle. When it stops, it spits up a "U6" error code which indicates insufficien...
Forum Discussion
By removing a couple of drawers (one below and one next to the DW), I was able to see just about all of the plumbing from the main water lines to the DW. I saw a small kink in the hose from the main line to the coupling into the hose that came attached to the DW. It did not look like enough to cause a problem, but I undid it anyway. I removed the coupling and saw that I was getting 2 gal/min of water through this hose! Then I reattached it and ran the dishwasher. It still failed.
Next I followed the DW's native hose up behind the unit with my hand because I could not find a good way to pull the unit from my cabinetry. Sure enough there was a HUGE kink in this hose! After cursing the installers at Thor under my breath a few times, I straightened the hose and I'm running the DW again. So far so good! Thanks for all your help. We took a picture of the hose before we straightened it. It doesn't appear that we can post pix on this message board, otherwise we would. I'm sure the photo will wind up in a blog or on our facebook page soon if you care to see the culprit.
Next I followed the DW's native hose up behind the unit with my hand because I could not find a good way to pull the unit from my cabinetry. Sure enough there was a HUGE kink in this hose! After cursing the installers at Thor under my breath a few times, I straightened the hose and I'm running the DW again. So far so good! Thanks for all your help. We took a picture of the hose before we straightened it. It doesn't appear that we can post pix on this message board, otherwise we would. I'm sure the photo will wind up in a blog or on our facebook page soon if you care to see the culprit.
