enblethen wrote:
Sounds like either the 120 volt element is bad, no 120 volt AC tounit or the circuit board.
Verify 120 volts AC is present at refer by testing receptacle with known good device.
AC present switch refer to AC and test output of the circuit board for 120 volts.
No 120 volts circuit board is bad. Replace with Dinosaur electronics after-market.
AC present, disconnect the two wires from circuit board. Test element for resistance. Should be somewhere around 20-30 ohms.( I think)
Thanks. I have verified power to the receptacle. Slowly moving forward.