Forum Discussion
Tershe
Oct 07, 2020Explorer
The pos probe is on the orange wire out of P1, which is 12 volt+. The neg probe is on the red wire out of P1, which is 12volt-.
I have just replaced the lower circuit board, with the same outcome, no DC output at P1. What else may interrupt the 12 volt input at the board from the output at P1?
I have just replaced the lower circuit board, with the same outcome, no DC output at P1. What else may interrupt the 12 volt input at the board from the output at P1?
About Technical Issues
Having RV issues? Connect with others who have been in your shoes.24,193 PostsLatest Activity: Jan 26, 2025