Drawers won't stay shut - Argh!!
The drawers on my TT have nice side mount metal glides with ball bearings in them. They run in and out smoothly. Trouble is, when I drive down the road most of them open up and slide in and out as I ...
Forum Discussion
BYU
Same drawer slides as on Quicksilver. Top notch IMHO. Tip: One smaller magnet each side of drawer = even drawer opening pull pressure. 5x3 mm N52 magnets seem to be perfect against a stainless steel tab. Recess magnet perfect pressure deep into the wood. They never break or wear out. Drill many micro starting holes for glue to bite and retain the SS plates. Sheet metal is perfect. I used sub floor adhesive.
Same drawer slides as on Quicksilver. Top notch IMHO. Tip: One smaller magnet each side of drawer = even drawer opening pull pressure. 5x3 mm N52 magnets seem to be perfect against a stainless steel tab. Recess magnet perfect pressure deep into the wood. They never break or wear out. Drill many micro starting holes for glue to bite and retain the SS plates. Sheet metal is perfect. I used sub floor adhesive.
