Drawing off two banks thru Switch?
I have split my 430Ah bank into two 215's, and I will soon be installing a Blue Sea switch with 1, 2, or 'both' settings. I realized last night, my cheapo 700w Walmart microwave, which is rated at 105...
Forum Discussion
BFL13 wrote:
Not sure how the load would be shared in that case.
My 700w Danby microwave wants 1050w input and on the Can Tire Xantrex 1000w PSW inverter, it runs ok, showing 1050w on the inverter's read-out, with the inverter showing the "overload" light on, but it still running.
Where did you measure the 12xx watts?
I only left it on for a few minutes to see if it worked, so can't say how it would do for say a 20 minute job. ISTR there is a short time it will keep running but then reverts to its "continuous" rating, but not sure.
Yes, mine is the Danby 700w, as well. My Xantrex Prowatt 1000 said 1280w draw. I just received my new clamp meter, so once I figure out how to use it, I will be testing everything in sight!
I was seriously looking at that Can. Tire 1000w inverter. They were on sale last year for about $160! How's that working out?
