Drip
I have a small drip coming from the 1 1/2" black pvc pipe from the gray water tank. Not sure where its coming from yet, could be the pipe or a joint? If I can find where the leak is coming from is t...
Forum Discussion
I had a thin spot in a bottom corner of my ABS holding tank. It became a flex point as the tank would fill and was leaking. I used Plasti-Mend and some thin sheet ABS to seal and reinforce the area. I think it is now going on eight+ years with no issue.
Initially tried JB Weld and some tank epoxy. Both failed. I believe they failed because of the continued flexing.
Initially tried JB Weld and some tank epoxy. Both failed. I believe they failed because of the continued flexing.
