Duo-Therm AC Shroud replacement

There have been BriskAir models that only used 4 screws- the pictured shroud will work with those. Basically, there are 2 "modern" BriskAir shrouds- a 10" and a 12". The 12" is the 10 with an added band riveted to the bottom. All are closed back now.
There is also the low profile Penguin- all of them use 4 screws, but they have no slots in them.

lj2654 wrote:
I have 2 screws in the sides near front and 2 in the rear only....hmmmm?

same here

Moved to Tech Issues

Wayne
Moderator

I have 2 screws in the sides near front and 2 in the rear only....hmmmm?

On our last TT which came from Texas, the whole shroud was very brittle so I lined the whole inside of it with fiber glass. It held up great!

Wow! They have a lot of differences

Mine appears to have a lower profile. I'll try to get the model number tomorrow...

At least all of your readers know that one size does not fit all. They will carefully check theirs.

Mine also has 5 screws per side holding the white shroud to the gray base.

My Model Number is 59530.532. Yours?

The shroud in your link wouldn't work on my Air conditioner.... the shroud on my AC is held on by a total of 4 screws

The one in the picture appears to be different than mine

and the one your link has at least 4 screws per side (8 total) ... and none of them are in the same place that the screws holes in my shroud are located.

The vent slots are different too

Did I miss something or is your AC different than mine?