EU2000i starts, then imediately quits..
Gas cap is unscrewed. Fuel pump puts fuel into the bowl. ?Starting fluid seems to have no effect. New and clean carb. Unit had not been started in a couple years. I found a bit of old gas in th...
Forum Discussion
groundhogy wrote:
Um...
I just put my finger on the exhaust pipe hole...
Pulled the cord a little.
I didn’t feel anything come out.
Is that bad? Lol
When you adjusted the valves, are you sure you were on TDC? Did you have to move them much to bring them into spec? If it ran before they shouldn't have needed much if anything.
Does it feel like normal resistance when pulling on the rope starter?
