The eyebrow board and power supply board arrived a short while ago. Before completely removing the power supply board and made certain to sketch a wiring diagram as well as taking a picture with the cellphone.
Installed the new power supply board and the refrig is now set to AUTO and the ELEC lamp is lit. This is an indication the refrig is working properly. When the refrig was turned on AUTO after installing the new board the ELEC and LP lamps were lighting back and forth, but now the ELEC lamp is lit solid. Now its time to wait for a few hours to see if it stays on ELEC without transferring to LP.
I have a new board for the eyebrow but will not install it as long as the refrig seems to be OK with just the new power supply board.
Hopefully I'll be updating this thread tomorrow to tell you all is AOK. Thanks for reading this link, many thanks to those that replied and hopefully we all learned something about refrig circuit boards.
