FW 120v ac wiring guidance
I just finished the install of a Progressive Industries EMS unit (EMS-HW50C) for our 50 Amp service FW. I also added a transfer switch for the 7KW Onan generator I am installing in the front bay. ...
Forum Discussion
Golden_HVAC wrote:
If you just remove the cover for the 120 volt circuit breakers, and determine what CB feeds each of the loads, and what you want to move, it will be easy to move one load from CB #1 to CB #2 leg.
Fred.
easy is a relative term. they didn't leave enough hot wire to just move the wire to another breaker. This distro center uses the plastic pinch retainers on the wire insulation.. so not only do I have to remove the breaker (swap sides with the 20 and 15 amp breakers) I have to remove all three wires and pry open the retainer to be able to pull the wire back out. times 2.
