HWH front right
As subject, jack is slow to none when operating. Just got this unit, 2014 PC with 325 model HWH. THERE WAS a 74”x24” mirror glued to a wall partition until the first time I tried leveling. Frame tw...
Forum Discussion
tarnold wrote:
Op. Thanks again Doug, I’ve printed off both references you pointed to. Finally quit storming so got to crawl under. Sprayed all friction points with PB blaster. Well watcha know, it works now, but don’t know if the spray was just a make me feel good action. Wiggling it didn’t seem to be bound up anywhere. Posts above mention a roller bearing. Hard to see/feel around but didn’t see anything that looked like a bearing. There is a stout rod with circlips on both ends that the unit pivots on. Is that the bearing? Now this part is confusing to me:
LF MOD #12447. RF MOD AP7164
LR. Ap7164. RR. 12447
SPRINGS HAVE 49 COILS.
funny to me the opposite corners model numbers match. What would be the reason for that? So good to go for now, thanks for responses.
Go to the Jack pic and it will state ROLLER BEARING. The Jacks. AP and RAP preceed the actual model number. The other 2 numbers, mean that they are RAP--Replacement numbers. That means those 2 jacks have been replaced at some time. The stout rod is the actuator. One thing, The jacks when retracted, should not be perfectly horizontal or tilt UPWARD. If so, they will not swing down correctly. You will see a Cable connected on both sides of the jack with adjustment nuts. You tighten to bring the retracted jack down slightly below perfect horizontal. Kick Down when adjusted correctly will yilt slightly downward. Doug
