HWH front right
As subject, jack is slow to none when operating. Just got this unit, 2014 PC with 325 model HWH. THERE WAS a 74”x24” mirror glued to a wall partition until the first time I tried leveling. Frame tw...
Forum Discussion
tarnold wrote:
Op again. Just spent more time looking for that roller bearing. As for mp65-3035 that is for a 9000# jack. Don’t look anything like mine. Mp65-3030 is what I seem to have 6000#, no bearing?
Correct. No bearing. But, Look at where it states Vertical stop adjustment. Does your Jack (all 4) tilt slightly down? If not, then tighten the vertical adjustment bolts to Pull the jacks down slightly. After 20 years the cables are probably slightly stretched.What I do is spray Liquid Wrench all over the pivot points to penetrate and remove any rust/corrosion that hinders the jacks from freely moving. You should be able to grab the foot and pull down vertical easily and the jack will smartly spring back up. Doug
