HWH hydraulic relay
My hydraulic slide sometimes stops on retraction. After a few minutes, it will start again and work. While I was checking voltages on the two hydraulic motor relays I found that the continuous duty re...
Forum Discussion
I have also replaced two resettable circuit breakers, (had another coach where they were weak and dropped out too soon.) Voltage checks at motor and relays are 14v.
The relays and motor also have separate in-line fuses that have not blown. (in addition to resettable circuit breakers on the main panel.
Trying to figure out what else would drop out, then come back online in 8-10 min. My first thought was weak circuit breakers or low voltage but ruled that out. Looking for the next logical thing that can reset. right now maybe the relays?
1. is it normal for a continuous duty relay to get too hot to touch (200+Deg.)?
2. Slide starts and immediately stops on retraction. then after 8-10 min retract ok what else in the system will do a reset>
The relays and motor also have separate in-line fuses that have not blown. (in addition to resettable circuit breakers on the main panel.
Trying to figure out what else would drop out, then come back online in 8-10 min. My first thought was weak circuit breakers or low voltage but ruled that out. Looking for the next logical thing that can reset. right now maybe the relays?
1. is it normal for a continuous duty relay to get too hot to touch (200+Deg.)?
2. Slide starts and immediately stops on retraction. then after 8-10 min retract ok what else in the system will do a reset>
