I have a mess and need help please
Long story short, got screwed over by not one, but two contractors. First one installed my living quarters. The second was hired to fix the first one's mistakes. They both checked out but didn't stop ...
Forum Discussion
Spay (or wipe) a little Clorox in there it will kill the mold, then set a small fan in there and let it dry a day or two, it will be fine. Fortunately that floor is plywood and not that OSB******that dissolves in water.
As far as the water tank, it may be OK. Get some this Rector Seal T+2, they sell it at both Lowe's and Home Depot. It's approved for use on both brass and plastic and for potable water. Take off the teflon tape and slather this on the male threads of the brass fiting and screw in gently. Don't overtighten and see if that does it. It's non-hardening so OK to use immediately.
Like Westend says, I would love to road trip out there and help if I didn't have a day job!
As far as the water tank, it may be OK. Get some this Rector Seal T+2, they sell it at both Lowe's and Home Depot. It's approved for use on both brass and plastic and for potable water. Take off the teflon tape and slather this on the male threads of the brass fiting and screw in gently. Don't overtighten and see if that does it. It's non-hardening so OK to use immediately.
Like Westend says, I would love to road trip out there and help if I didn't have a day job!
