Inverter not putting out 110V
I have a Vector Maxx-SST VEC062 700w-1000peak inverter that is now only putting out 94v. Input is 13.6v, short (16")8g leads to the converter and batteries are good, all on and connected to shore. M...
Forum Discussion
OK-apparently some of you can't read and absorb what I said. I normally don't use the inverter except when not on shore power.
Today, when I took my readings (yes it's a good Fluke true RMS meter)to back up my memory of what has happened in the past I was hooked up to shore power and was getting Voltage from the converter. When I test, I test under load so converter went to 13.6 from 13.2. That just to clarify
When input volts are low, output AC will be low. Today to be sure, input was a strong reading, and one would expect inverter to put out proper 120v. I have another inverter hardwired that is OK.
My question is-is there an adjustable pot or something to bring this back to spec?
Today, when I took my readings (yes it's a good Fluke true RMS meter)to back up my memory of what has happened in the past I was hooked up to shore power and was getting Voltage from the converter. When I test, I test under load so converter went to 13.6 from 13.2. That just to clarify
When input volts are low, output AC will be low. Today to be sure, input was a strong reading, and one would expect inverter to put out proper 120v. I have another inverter hardwired that is OK.
My question is-is there an adjustable pot or something to bring this back to spec?
