LED lights and Resistors
I am replacing all the marker lights, side clearance lights, and tail/stop lights with sealed LED fixtures. Where do I need to add resistors (and what size) to make the turn signals work correctly? Al...
Forum Discussion
Electronic flashers (a good one) needs a lot less pull down load (added resistor) than the old fashioned 1/4 ounce flashers. I use 100% LED and find even with a minimum of load adding a TEN WATT ONE OHM CERAMIC RESISTOR to the flasher "X" terminal is plenty enough load to make the flasher work.
Oooo Oooo Oooo I can hear the "ONE OHM REQUIRES 12 WATT RESISTOR", from here. The signal is INTERMITTANT so the 10 watt resistor will do fine as long as it is kept in open air.
Oooo Oooo Oooo I can hear the "ONE OHM REQUIRES 12 WATT RESISTOR", from here. The signal is INTERMITTANT so the 10 watt resistor will do fine as long as it is kept in open air.
