LiFePo4 voltage under load
Hi all, This is the first chart (stage left graph when looking at the image) I've been able to find that shows voltage under load. I may be reading it wrong.
Forum Discussion
3 tons wrote:
BFL says: “IMO the real LFP figures in the OP graph should only go to the "knee" and use about 12.5v as the "end voltage". That would make the times approx”
Fair enough, but consider too that in actual practice 12.5v occurs somewhere below the chart’s stated 10% SOC - in my case this works out to around 97ish % DOD…
3 tons
I run mine down to about 12.4 on each charge cycle and just let my Redarc re-charge until it goes into float.
