lippert schwintek slide system problem
We have a lippert schwintek slide on our bedroom slides. The small one was dragging and I had to assist in in retracting by pushing on it to get it to fully retract. I found a piece of gasket that ...
Forum Discussion
Should be able to 'sync' motors
Resynchronizing the Slide-out Motors
*Fully extend the slide room using the switch. Keep the switch engaged until the motors shut down on
their own.
*Retract the room 1-2 inches.
*Repeat steps 1 and 2 until both motors shut down at the same time. In many cases, two or three repetitions are necessary to re-sync the system.
*Fully extend and then retract the room. Again, always let the motors shut down on their own before releasing the switch.
LCI Schwintek Owners Manual
Resynchronizing the Slide-out Motors
*Fully extend the slide room using the switch. Keep the switch engaged until the motors shut down on
their own.
*Retract the room 1-2 inches.
*Repeat steps 1 and 2 until both motors shut down at the same time. In many cases, two or three repetitions are necessary to re-sync the system.
*Fully extend and then retract the room. Again, always let the motors shut down on their own before releasing the switch.
LCI Schwintek Owners Manual
