Mean Well power supply for my usage
I've been reading old threads for a couple of hours. I'm fairly sure a Mean Well p.s. can do what I want to do, but I'd appreciate if one of you early adopters can point me to a specific model, etc. ...
Forum Discussion
Snowman9000 wrote:BFL13 wrote:Snowman9000 wrote:
No, I am NOT looking for float!
I'm looking for a charger to put in a lot of AH in 2 hours of run time on an Onan genset. Period.
I gots float otherwise covered.
And equalizing too.
:)
I gots confused by you asking so often whether the mod PM3 did float. :)
The tangents make it hard to keep up.
I was trying to make sure I understood what it does and doesn't do. It sounds like it would do what I want: Full amps till full volts reached, then hold the volts while amps taper. Unless it's now unreliable or flaky in some way? I would retain the regular wfco converter for converting, float charging, etc.
Yes.
Yes.
Yes.
Buy one already. Set it at 14.8V or 15.0V add wire, mount it out of the elements, close to the batteries, in storage area, and run fat wire, call it good.
Your needs are the same as mine, it works fine. Always connect to the battery first before turning on the PSU.
