Momentary switch on my Powergear Slide
So it seems if I stop retracting then start again to finish the cycle, the extend (yes extend)side of the momentary switch fails. When I push the extend side nothing happens, but if I push the retract...
Forum Discussion
MEXICOWANDERER wrote:
This is a "me learning" question...
None of these slides use limit switches?
NOT mechanical limit switches. They use a amp controlled electrical limit switch. Some use a CLUTCH, that rachets when fully extended or retracted. When the amp draw increases from a stopped movement, the Control sees that raise of amp draw and disconnects the power to the motor. Doug
