Forum Discussion
jrnymn7
Jan 30, 2015Explorer
BFL,
If panel Isc is say 7a, at 14.8Vabs, then in series it would remain at 7a, but in parallel it would double to 14a. So in my example, when the switch happens from bulk to abs, there would still be a sudden and significant drop in current... 14a down to 7a, instead of 16.4a down to 8.2a. So the issue would still exist, correct?
------------
I do keep forgetting about that 13.x volt kick in setting.
------------
But, apparently, Jim sees current above and beyond Isc... while still in pwm mode. How is this possible? What, other than the bucker, could do this?
If panel Isc is say 7a, at 14.8Vabs, then in series it would remain at 7a, but in parallel it would double to 14a. So in my example, when the switch happens from bulk to abs, there would still be a sudden and significant drop in current... 14a down to 7a, instead of 16.4a down to 8.2a. So the issue would still exist, correct?
------------
I do keep forgetting about that 13.x volt kick in setting.
------------
But, apparently, Jim sees current above and beyond Isc... while still in pwm mode. How is this possible? What, other than the bucker, could do this?
About Technical Issues
Having RV issues? Connect with others who have been in your shoes.24,262 PostsLatest Activity: Jun 09, 2025