Norcold 120 volt heating element
I have a Norcold model 6162. It blows the 5 amp fuse on the power board at times. How many ohms should I read across the heating element ? How many amps should this heating element draw? I m...
Forum Discussion
Should be 48 ohms, 2.9 amps @ 120 volts, 300 watts.
Does the fuse blow violently, or just melt? These fuses do have a tendency to melt because of corroded fuse holders, but they can also have an intermittent short in the heater (short when it gets hot).
I use penetrating fluids- they burn off quickly without igniting on 120 volt power.
Does the fuse blow violently, or just melt? These fuses do have a tendency to melt because of corroded fuse holders, but they can also have an intermittent short in the heater (short when it gets hot).
I use penetrating fluids- they burn off quickly without igniting on 120 volt power.
