Old-Biscuit wrote:
No spark.....
Spark gap incorrect......should be 1/8"-3/16" between tip and burner
IF spark gap is correct and no spark
Will check that tomorrow when I've got the right tools along so I can get to it.
Old-Biscuit wrote:
Check continuity between unplugged end and sensor. No continuity replace.
Continuity was good on the wire. Didn't have the right tools to remove the drip cup so I wasn't able to pull the igniter and check for a cracked ceramic casing.
Old-Biscuit wrote:
Does fridge work on AC....cools good?
Yes, it works fine on AC
Old-Biscuit wrote:
And if the DC fuse in DC Dist. Panel was blown you would not be able to operate fridge at all.......NO lights on panel.
The red indicator LED in the dist panel that indicates a bad fuse was on but so were the LED's on the fridge when I switched it from off to gas. The fuse itself didn't have what I'd call a clean burn through, but it was definitely in need of replacement so maybe just a partial melt and enough juice getting through to light the LED's on the fridge.
Thanks for all the info. I'm leaning toward something on the board or the igniter and won't waste my time on an unnecessary reset.