enblethen wrote:
What method are you checking 120 volt power to refer?
Use a known good item such as a drill to test receptacle.
A volt meter in some cases will read induced voltage.
Verify connections in 120-volt distribution panel.
Remove receptacle from refer access. Some of the rigs use stab type receptacles that don't always make good contact.
Was using a dmm to check for 120v at the fridge supply cable,and across fuse terminals on control board. Panel was fine, nice and tight on buses. As stated earlier, can't access receptacle as it was installed very high up, cooling unit in the way. But I just tried with the 2nd outlet on refer recept, and that one is working. No signs of arcing or oxidation on refer plug, so hard to tell what happened. Still think I'll disconnect that outlet, and rewire something more accessible. Thanks for the info.