Onan 3.6 KYFA LP Generator won't stay running
Hi Everybody, I have a 2006 Carriage with an Onan 3.6 LP generator installed. It has a remote starter and the starter on the unit. I had my rig at my mountain property for about 4 years and visit...
Forum Discussion
from my manual:
GENSET RUNS BUT STOPS WHEN SWITCH IS RELEASED – NO FAULT CODE
WARNING Some genset service procedures present hazards that can result in severe personal injury
or death. Only trained and experienced persons with knowledge of fuels, electricity, and machinery
hazards should perform genset service. See Safety Precautions.
Logic: Fault codes are based on time lapse between events
Possible Cause: Not holding start switch long enough to cause fault
Diagnosis and Repair:
1. Check and record last fault code.
2. Start genset and hold switch until control shuts down and displays fault code (approximately 30 seconds):
troubleshoot fault code and reference last fault code recorded above if necessary.
GENSET RUNS BUT STOPS WHEN SWITCH IS RELEASED – NO FAULT CODE
WARNING Some genset service procedures present hazards that can result in severe personal injury
or death. Only trained and experienced persons with knowledge of fuels, electricity, and machinery
hazards should perform genset service. See Safety Precautions.
Logic: Fault codes are based on time lapse between events
Possible Cause: Not holding start switch long enough to cause fault
Diagnosis and Repair:
1. Check and record last fault code.
2. Start genset and hold switch until control shuts down and displays fault code (approximately 30 seconds):
troubleshoot fault code and reference last fault code recorded above if necessary.
