Oven burner problem
Hello, I just got a rv ford econoline 90. I filled the gas tank and try the furnance. Water heater works good, stove also but im haven problems with the oven. I put it in pilot mode and use ...
Forum Discussion
This is a PDF you need to go down to about paghe 50-55 to find the Range and oven.
I did not find what I was looking for in the manual
This is from memory, which I believe to be soild
YOu turn to PILOT push. light the pilot and hold for 1 mintue or more. Then release and turn to like 350
The pilot is a small flame. think candle, the main burner is a larde OVAL or two lines runs the "Depth" of the oven (From back to front) and should light up. the flame will "Travel" at first (from one end to the other) this burner should cycle to maintain heat.
The probe (Thermocouple) inside the oven is just what you think it is
The pilot sensor should be in the area of the flame of the pilot it is a thermocouple generating about 0.480 volts when hot and the current that sends through a magnet in the valve assembly to lock things "ON"
finally... I found mine to be rather far off so use an oven thermometer please.
I did not find what I was looking for in the manual
This is from memory, which I believe to be soild
YOu turn to PILOT push. light the pilot and hold for 1 mintue or more. Then release and turn to like 350
The pilot is a small flame. think candle, the main burner is a larde OVAL or two lines runs the "Depth" of the oven (From back to front) and should light up. the flame will "Travel" at first (from one end to the other) this burner should cycle to maintain heat.
The probe (Thermocouple) inside the oven is just what you think it is
The pilot sensor should be in the area of the flame of the pilot it is a thermocouple generating about 0.480 volts when hot and the current that sends through a magnet in the valve assembly to lock things "ON"
finally... I found mine to be rather far off so use an oven thermometer please.
