Problem with bedroom slide out UPDATED
Please see my post on page two where I detail what the solution was! I went back over to the storage yard to verify what type of system that I have and it is the Lippert system. I attached a phot...
Forum Discussion
OP Again,
I went back over and did more troubleshooting. I am getting 8 RED and 2 GREEN flashes' on the controller. According to what is printed on my controller it means "wire short between controller and motor" for motor number 2.
I did some more searching and found that this could still be one of two things. Either the wire between the controller and motor is bad or according to Lippert the motor could be defective and need replaced.
How can I determine which is bad? Please remember I have very little knowledge of electronics etc. so any responses need to be in everyday terms so a simpleton like me can understand.
Dave
Dave
I went back over and did more troubleshooting. I am getting 8 RED and 2 GREEN flashes' on the controller. According to what is printed on my controller it means "wire short between controller and motor" for motor number 2.
I did some more searching and found that this could still be one of two things. Either the wire between the controller and motor is bad or according to Lippert the motor could be defective and need replaced.
How can I determine which is bad? Please remember I have very little knowledge of electronics etc. so any responses need to be in everyday terms so a simpleton like me can understand.
Dave
Dave
