Progressive Dynamics 9260 possible issue
Hoping to solicit a bit of advice from the gurus here. I recently installed a PD 9260 and it seems to do a much better job charging my (2) Trojan T105 batteries. The only issue is, the converter ...
Forum Discussion
More info for comparison. My 9160A with zero load on the output draws 10 watts from the power line. With a 1 amp load, the AC power draw goes up to 25 watts, 13.6 into the battery and 11.4 going up as heat from the converter. After pushing that 1 amp for a few hours, the converter case and heat sink are at about 90 degrees, with the compartment temp at 70 degrees (measured with an infrared "point and shoot" thermometer).
