PWM input voltage, Xantrex C40 test video
here is the Video link, the fluke is plugged directly into the Solar panel drop wiring before it enters the controller right above the panel input protection fuse, that i use for a disconnect just c...
Forum Discussion
Back on limited internet. I just checked my old PWM, 130w set-up that I sold to my camping neighbour last year.
Last week I reported it was in Bulk and ISTR the voltages were maybe 13.6/13.5 or some such (not sure which thread I posted that in) Anyway, it was as expected with the two voltages close.
Today his battery bank has reached the controller's high voltage set point near 14.3, and the battery side is 14.34v. The array side is 19.10v.
Last week I reported it was in Bulk and ISTR the voltages were maybe 13.6/13.5 or some such (not sure which thread I posted that in) Anyway, it was as expected with the two voltages close.
Today his battery bank has reached the controller's high voltage set point near 14.3, and the battery side is 14.34v. The array side is 19.10v.
