Thanks for the information, a lot to digest.
When I got home last night, the panel array had harvested more than enough power to run the RV. And that was on the side of my house where the array was partially shaded for several good sun hours due to neighboring houses and trees.
We pulled it out to the lake last night and got it set up with the intent to return tomorrow night to camp over the weekend. There are no shade sources anywhere close so I am hoping to see even greater harvest.
I know this question is probably highly dependent upon the individual controller I have (Renogy Adventurer 30A), but will it "count" amp-hours harvested even if it can't use them to serve loads or charge the battery?
For example, if the load on my unattended camper is only 20Ah per day but the array is capable of harvesting 40Ah, would my controller say that I harvested 20Ah or 40Ah?
The controller has a logging feature on the bluetooth enabled app, so when I get there tomorrow night I should be able to see what it harvested today and tomorrow.