Forum Discussion
wa8yxm
Oct 14, 2023Explorer III
There may be two lights.. You mentioned "The red light on the switch"
On my water heater the switch lit up red if turned on.. That way you knew if Gas or Electric was on) then there was a FAULT light (All red)
The RED fault light... Indicates one of two conditions.
ONE Over temp (Emergency Cut Out) sensor activated (See notes) That's on any mode.
Two Flame not detected after 3 tries to light (Gas only)
NOTES. The ECO is a disc thermostat I think it's like 190 or 200 degrees.
But the wires going to it can "Tarnish" and lose connection.. So it might be over temp.. Or broken wire, or bad connection Or control board failure or _________ (Fill in the blank).
On my water heater the switch lit up red if turned on.. That way you knew if Gas or Electric was on) then there was a FAULT light (All red)
The RED fault light... Indicates one of two conditions.
ONE Over temp (Emergency Cut Out) sensor activated (See notes) That's on any mode.
Two Flame not detected after 3 tries to light (Gas only)
NOTES. The ECO is a disc thermostat I think it's like 190 or 200 degrees.
But the wires going to it can "Tarnish" and lose connection.. So it might be over temp.. Or broken wire, or bad connection Or control board failure or _________ (Fill in the blank).
About Technical Issues
Having RV issues? Connect with others who have been in your shoes.24,187 PostsLatest Activity: Jan 14, 2025