Removing 50 Amp RV Surge Protector

Are you installing in the middle of a long wire run? Or near one end?

If near the end just disconnect the wire and connect to the EMS direct. No cut. Then add a short romex from the EMS to the place where you disconnected. Upon removal just put it back oem.

See what you mean now. I found some other types on the net but would be looking at $80 to do it. I'll keep looking. Thanks

Lenny K wrote:
Thanks SoundGuy. Exactly what type of 50 connectors are you talking about?

I used 30 amp TT connectors and pigtails to install my EMS-HW30C 'cause I already had most of what I needed in the workshop but one could alternately use twist lock connectors, in your case the 50 amp versions.

Installing a Hardwire EMS Using Connectors

Thanks SoundGuy. Exactly what type of 50 connectors are you talking about?

Lenny K wrote:
If I was to cut the wire to install a Progressive Industries EMS-HW50C Hardwire 50 Amp RV Surge Protector in my trailer and then if I sell the trailer and want to remove it, would it be acceptable to rejoin the wires in a junction box?

Sure ... or better still, install it using 50 amp connectors, that way you can remove it at any time for any reason.