RV dinette light wiring questions
Finally getting around to trying to replace this. OK, I procrastinated, used duct tape, and then it all fell apart (down) on yesterday's drive. When it fell a lot of the wiring came apart. There ar...
Forum Discussion
Or a switch!
Run a meter lead to the shell of a close by light, set meter to resistance to check if the ground is good.
Next, change meter to a 20 volt or so scale. put one lead to shell of adjacent fixture, touch other lead to line (green wire0 to check for voltage.
Run a meter lead to the shell of a close by light, set meter to resistance to check if the ground is good.
Next, change meter to a 20 volt or so scale. put one lead to shell of adjacent fixture, touch other lead to line (green wire0 to check for voltage.
