Should I swap GC2s out for Lifeline AGM?

Yep. Batteries have characteristics and moods. Anything that costs as much as a good AGM keeps me situationally - aware.

The Bayite Hall effect ammeter on my dashboard is my most looked at gauge, then the digital voltmeters, with their voltage control dial right next to them.

Knowing the Amperage the batteries are accepting at absorption voltage is extremely enlightening, and more so the more one observes that amperage at from different states of charge.

Being able to change target voltage and watch amperage respond upto the maximum altnerator output for that RPM is also extremely enlightneing, but I can do the same with my meanwell, upto the 40 amps maximum.

Five or six hours at 14.4 otter doer. You can do simple math vs remaining capacity then add 130% more time, wake up in a lawn chair stumble over to the generator and press the "noiseless" button and go about your business.

Slosh batteries have their place. Forklift and other industrial batteries commonly have plates up to 300% the thickness of the thickest AGM battery. For hot climes electrolyte can be adjusted for tropical blend. Of course the bank amp hours has to see a gross increase via more batteries because of weakening of jar amp hours -- but the overall lifespan can see an amazing increase.

If you are satisfied with your battery then who can criticize? But like Einstein quipped "The definition of insanity is to do something exactly the same way over and over -- and expect different results"

Complaining about battery performance and lifespan then running out and buying yet another dollar store grade battery would fit that definition.

landyacht318 wrote:
I do not miss flooded battery maintenance and much rather watch an ammeter to determine full charge, as opposed to a hydrometer

You said a mouthful there!

That especially applies when your ammeter is permanently mounted right on the dash so you can check/monitor what's happening whenever current is supposed to be going out of, or into, your RV batteries. ;)

I can't use a battery over 9.5 inches tall without serious modifications and some sacrifices of storage space.



I love a battery which can gobble up huge alternator amperages without worry. I do not want a battery with a recommended 10 to 13% charge rate, or an AGM with a sub 33% charge rate.

Been hammering a Northstar AGM for 800+ deep cycles for approaching 5 years.
Been two years since I last saw the top of it.

Previous flooded marine 27s were always compromised further, by not watering them in time but they were also a huge PITA to fully charge.

I do not miss flooded battery maintenance and much rather watch an ammeter to determine full charge, as opposed to a hydrometer

Hahaha I wonder (not) how much a 3300 amp hour 24 volt Lifeline battery replacement for my Rolls flooded batteries would cost. This isn't even a serious consideration...

In this one case I am sure the Rolls would outlast the Lifelines.

But checking electrolyte on wide-open 30" tall batteries is not in the same league as hassling with ensconced motorhome batteries. I have to lay down a foam pad when checking the batteries in Quicksilver or I get a rather acute case of the Kneezles.

I got AGMs for the truck camper we had because they had to be inside and no flooded fumes allowed. Moved them to the MH we got later, same thing --inside--plus got another AGM to add to the bank. (Now at 450AH of AGMs)

All inside where also --this is big!-- they stay warm in the winter so they don't lose tons of AH in the cold as when outside. Win-win!

The batts go under a dinette seat along with other electrical stuff, and the opposite dinette seat covers the fresh water tank.

So add to the "reasons" list:
A. no fumes
B. keep warm inside= no capacity loss in cold outside temps.

Unfortunately that does nothing to help with their bad AH per dollar cost. :(

time2roll,

Probably my own fault. I ordered them from Camping World. They took 7 months to ship them to me. They were encrusted with dust.

Had mine at least five years now with no issues. Swapped to the new batteries when replaced.
Sorry for your troubles. Really like mine so far. (knocks on wood)

So now it is transfer switches AND battery watering where we recommend the opposite. Just part of the adventure ;)

Hi,

I had one with a pump. It broke repeatedly.

time2roll wrote:
I have to say I have not missed checking electrolyte levels since installing an auto fill system.