surburban furnace will not light
sf -35 # 963105899 in 97 allegro bus. Furnace goes thru steps but does not light. I have 12 volts to relay, temp sensor, sail switch , to circuit board. Fan runs ,But I do not smell propane out exhua...
Forum Discussion
Yes........if there is an outside panel it will come out that way.
(Some SF & SH don't have an outside panel just vent/exhaust thru side of rig...they have to be removed from inside)
2 screws hold outside panel in place
1 screw (bottom center) holds furnace in place
Then the whole assembly slides out..provided gas line/wiring disconnected
Here is a write up on SF Series......LINK
Check the ignitor board part number.......replace with one from Dinosaur Boards......LINK
(Some SF & SH don't have an outside panel just vent/exhaust thru side of rig...they have to be removed from inside)
2 screws hold outside panel in place
1 screw (bottom center) holds furnace in place
Then the whole assembly slides out..provided gas line/wiring disconnected
Here is a write up on SF Series......LINK
Check the ignitor board part number.......replace with one from Dinosaur Boards......LINK
