TRUENORTH60 wrote:
So, the level indicator for my black tank seems to have two indications; 3/4 full or full. Even if I drain the tank, the monitor still shows 3/4 full. I can look straight down the toilet and see that the bottom of the tank is not covered with . . .. .. ahem .
You have described a very large percent tanks in use today. That is normal operation I'm sad to say.
NOW. if you can see into the black tank, and see the sensors, Then there is a good chance you can blast them. I can not guarantee but this MIGHT work
Look up a valterra
Master BlasterNow I do not care for this design exactly. I'm afraid that "nose" jet would break off first time I use it. but some half inch PVC and a pipe cap and a 7/32" drill (Chosen by what was handiest do not feel obligated to use that size) and drilled a hole in the side.. Tha's my Wand. Or you can use a 90 degree elbow and cap it and drill the cap (Actually that's what I did center drilled the cap) much stronger, same concept. And from time to time I've enjoied Success. (not often) but I've cleared that 2/3 (in my case) sensor fairly often
Next option: Horst Miricle probes (Google them)
Ultimate option See Level sensors
I'm also gonig to try somnething eventually, but I got to buy 'em first no report till then.
