Trimetric Monitor and Battery Charging Help
I have a WFCO 8930/50 Converter/Charger in my 5th wheel. On the WFCO website is states that it will not go into bulk charge unless the batteries are severely drained or some other maintenance issue. T...
Forum Discussion
One of the problem I had with the WFCO WF-8945 Charger that would always stay at 13.6VDC was after a few hours of charging it would start boiling out battery fluids... I replaced my WFCO with a 60AMPS Progressive Dynamics PD-9260C model...
This is one of the main reasons for the smart mode charging... It starts with 14.4VDC for an hour then drops back to 13.6VDC for a few hours then drops back to 13.2VDC for several hours to finish off the full charge. No boiling out of any fluids...
This is what I experienced at any rate using my Progressive Dynamics PD9260C Smart Mode charger setup...
Roy Ken
This is one of the main reasons for the smart mode charging... It starts with 14.4VDC for an hour then drops back to 13.6VDC for a few hours then drops back to 13.2VDC for several hours to finish off the full charge. No boiling out of any fluids...
This is what I experienced at any rate using my Progressive Dynamics PD9260C Smart Mode charger setup...
Roy Ken
