Unable to install P.I. EMS HW30C bypass
Tried to finally install a factory remote bypass on my EMS. Procedure is simple, except… Instructions state to put the remote’s black wire on the empty spade lug under the white neutral input wire. T...
Forum Discussion
CA Traveler wrote:Bobbo wrote:It is a data cable similar to a phone cord.
I'm confused. I thought the remote display/disconnect was a data cable similar to a phone cord or ethernet cord that just plugged into a connector on the EMS case.
As a side note, a phone cord actually works perfectly for this. I used a standard RJ11 jack phone cord and in-line coupler to extend mine - even though the manual says otherwise.
