Water heater issues
Hi. I have a 6 gallon Atwood water heater. it is electric/propane. When I switch it to electric it works fine but when I switch it to gas, it lights then goes out. Below, I have attached a link to a v...
Forum Discussion
Lorinmc3 wrote:Yes if you go on Atwood web site at the end of the manual it tells you how to test them using an ohm meter. Also if you have a newer non potted board you can look at the back to see if there is any arcing. As a little more incite there are about 3 grounding points to check and clean as well as all other connections. The igniter can be cleaned and adjusted. I could not tell if you igniter was clicking form the video?
Thanks for that info. Is there a way to test the circuit board to make sure that's the problem?
