Water heater problem made worse
My 6 gal Atwood G6A-8E HW would not stay lit,it would light and stay clicking then shut off. I replaced the flame sensor last year so I decided to clean the electrical contacts orifice and flame senso...
Forum Discussion
It's just a ground so you can certainly try re-attaching. In my case, the wire was actually corroded and pulled away from the coil. Soldering might stay put, but I would just replace.
The price you listed is quite high. Look on Ebay or Amazon. You can find a new valve for around $80, delivered.
I just replaced the board on my old American Appliance (pre-Suburban buyout) 6 gal. DS water heater with a DinosaurElectronics.com board. I can't speak highly enough about them.
Jose
The price you listed is quite high. Look on Ebay or Amazon. You can find a new valve for around $80, delivered.
I just replaced the board on my old American Appliance (pre-Suburban buyout) 6 gal. DS water heater with a DinosaurElectronics.com board. I can't speak highly enough about them.
Jose
