Which Screw Gun for Jacks?
I used my old Dewalt 12 volt nicad screw gun for years to lift and lower my stabilizing jacks. It finally bit the dust and I replaced it with a much smaller 12 volt lithium ion Bosch. Nice to handle, ...
Forum Discussion
Never done that with the back jacks, but I if I did, I would use my 120v drill like some do AFAIK.
Only thing is the drill is a bit slower revving on MSW inverter than with PSW inverter/gen/shore power, so that might be an issue with the jacks, no idea.
I know that helps a lot! :)
Only thing is the drill is a bit slower revving on MSW inverter than with PSW inverter/gen/shore power, so that might be an issue with the jacks, no idea.
I know that helps a lot! :)
