I'm accustomed to having ready access to CNC plasma/water tables (I have very good friends) and high end welders. I recently moved from SoCal to NorCal and no longer have those resources at my finger tips. Now its a 110v flux core welder and an angle grinder..
So off to home depot I go for some angle iron and bar stock. I will not have this happen again.
Not many pictures during the work, but I'll throw a few down here:
Crude fabrication. Its like the mid 1990's all over again.
And the best Krylon has to offer.
Carefully cut out the trim on the camper with the sawzall to make room for the mounts to go in.
Everything looks so much better before Dicor goes on.. :(
I can't say I'm 100% thrilled with the aesthetic of how it turned out, but I have more dollar value damage to my truck than I have spent on the camper, including new jacks and hot water heater.. so better cheap and right than holding out and tearing things up again.
