DRW Swing out bracket extensions? .

Question

Pros and Cons on adding extension beyond basic swing out?

Seems like at least once a season I have to buff out rear fenders from loading/unloading the T/C. Have been thinking about a simple plate, piece of steel to move out. Seems like only real limitation is keeping from blocking rear cab door
Has anyone actually done this???

mkirsch · Answer

TCBob wrote:Pros and Cons on adding extension beyond basic swing out?Seems like at least once a season I have to buff out  rear fenders from loading/unloading the T/C.  Have been thinking about a simple plate, piece of steel to move out.  Seems like only real limitation is keeping from blocking rear cab doorHas anyone actually done this???I'm familiar with limited clearance. The feet on my jacks rub the tires as I'm backing in.What's nice about being tight is that if you get between the jacks, you're home free, perfectly centered.My first recommendation is to back up more carefully. If you see it headed for the fender, STOP, pull ahead, and readjust. Don't just keep backing until you hear that sickening scrape.You only have 3/4" of clearance on each side at the wheel wells, so if you have that much or more on the outside, you've got plenty of clearance.I adjust the mirrors to point right at the fenders so I'll know if I'm going to hit.

reddog1 · Answer

I am in the process of extending my swingouts now. I have one finished and bolted on. My Bigfoot has the jack mounts anout 2-3 inches inside from the outside of the TC. I am extending the jacks out 4 inches. I used 2"x4"x1/8" wall rectangular tubing. If I remember, today I can take photos if you are interested.I do not like it tight because sometimes I have to go under the TC at a slight angle, then align.Wayne

hms_beagle · Answer

I had to add them to my F350 for the Bigfoot 9.6. Even with the swingout brackets, there was about minus 1" clearance between the fenders and jacks. It simply did not fit. I used 2x2x1/8 wall tubing to space them out, but worried about the additional stress on the camper attachment, already stressed a bit by the swingout offset. So I welded 1" tubing across top and bottom, to take the torque introduced by the offset. I don't think I have picture of it but I will look. It worked perfectly for 12 years. My new 10.4 Bigfoot has the camper attachment mounted further out, so with dually swing outs, the jacks clear by about 1" each side, plenty of clearance.

bedlam · Answer

My Arctic Fox with swing out brackets leaves plenty of room for my 8' wide flat bed. I think those of you that are having clearance trouble have narrower TC's. Aluminum U-channel between the jack and swing out bracket has been a popular method in the past to gain additional clearance. You may have to clock your jack motors so they do not interfere with the rear of your cab or doors when the jacks are swung in.

reddog1 · Answer

HMS Beagle wrote:... I used 2x2x1/8 wall tubing to space them out, but worried about the additional stress on the camper attachment, already stressed a bit by the swingout offset. So I welded 1" tubing across top and bottom, to take the torque introduced by the offset. ...I can't visualize where you welded the 1" tubing across the top.I think the way they mounted the jack brackets on my 1988 Bigfoot is as strong as it gets. I see nothing that concerns me with added stress.

Forum Discussion

DRW Swing out bracket extensions? .

8 Replies

About Travel Trailer Group

Related Content

Swing out jack brackets

Swing away Honda bracket.

Are Dually Extension Brackets Unsafe?

Swing bracket install help

Show me your swing out brackets