Ok, lets just say for chits and giggles I weigh..aaa..lets say 260. With the camper suported on the same structure as if it was in the bed of the truck not secured ,if there were 260lbs in the master bedroom area theres no way it can teiter correct? ThanksEd

It would likely be ok, but it depends on how much the rest of the TC weighs and how that weight is distributed.

Is that 260 pounds in the master bedroom static or dynamic weight :@

Here's a fairly easy way to tell if the camper is in the truck. Unhook or loosen the tie-downs. Have someone stand outside of the camper and watch while you get up in the front of the camper and bounce around - put two or three of you up there.The person watching can tell if the rear of the camper is coming up off of the bed of the truck. The most it can tilt is a couple of inches because the roof of the truck is right there below the bed.Bill

If they could tip over from someone in the cabinet bed do you think that they would ever be on display at the dealer lot just standing on the jacks?

Fulcrum point | Good Sam Community

43 Replies

Trackrig
Explorer II
Aug 28, 2016
Here's a fairly easy way to tell if the camper is in the truck. Unhook or loosen the tie-downs. Have someone stand outside of the camper and watch while you get up in the front of the camper and bounce around - put two or three of you up there.

The person watching can tell if the rear of the camper is coming up off of the bed of the truck. The most it can tilt is a couple of inches because the roof of the truck is right there below the bed.

Bill
gbopp
Explorer
Aug 28, 2016
Is that 260 pounds in the master bedroom static or dynamic weight :@
jimh406
Explorer III
Aug 28, 2016
It would likely be ok, but it depends on how much the rest of the TC weighs and how that weight is distributed.

Forum Discussion

Fulcrum point

43 Replies

About Travel Trailer Group

Related Content

5% tipping point

Lippert six point levelling jacks

Low point drains

Multiple access points?

Pointing Dish Playmaker